10
䡲 FILTER –
䡲 Turn the Rotary Switch (1) until the following message is displayed:
䡲 HARDNESS
䡲 Now press the Rotary Switch (1) to start the programming.
䡲 LEVEL 3
䡲 Turn the Rotary Switch (1) until the required level is displayed.
䡲 For example, LEVEL 4
䡲 Press the Rotary Switch (1) to confirm the required level.
䡲 HARDNESS
䡲 Turn the Rotary Switch (1) until
EXIT appears
䡲 Press the Rotary Switch (1) to leave the programming mode.
䡲 READY
5. Installation of CLARIS plus filter cartridges
If the CLARIS plus filter cartridge is installed properly, descaling
of the coffee machine is no longer required. For more infor -
mation on the CLARIS plus filter cartridge refer to brochure
‘CLARIS plus. Hard on limescale. Gentle on your coffee
machine.’
5.1 Installing the filter
Draw off 1/2 litre of water to rinse filter completely. In order to
ensure perfect operation, close tap (14) only after the display
says
CLOSE TAP
䡲 Fold up the cartridge holder. Install the filter cartridge in the water
tank, applying a gentle pressure (Fig. 1).
䡲 Fold down the cartridge holder again until it engages audibly.
䡲 Fill the water tank with cold, fresh tap water and install it again.
䡲 Press the Rotary Switch (1) until
FILTER –/⻫ appears
䡲 FILTER –
䡲 Press the Rotary Switch (1) to start the programming.
䡲 NO –
䡲 Turn the Rotary Switch (1) until the following message is displayed:
䡲 YES ⻫
䡲 Press the Rotary Switch (1) to activate the filter cartridge.
䡲 INSERT
OPEN TAP
䡲 Put a sufficiently large container (at least 0.5 litre) under the Pro-
fessional Cappuccino Frother (15) (Fig. 10).
䡲 Turn the selector switch of the Professional Cappuccino Frother (15)
to the steam position (Fig. 20).
䡲 If not installed already, insert the CLARIS plus filter.
䡲 Open the steam / hot water draw-off tap (14) (Fig.12).
䡲 RINSING
FILTER
䡲 CLOSE TAP
䡲 Close the steam/hot water draw-off tap (14), now the IM PRESSA will
heat up to coffee temperature.
To Next Page
Loading...
