23
2 Preparing and using your IMPRESSA for the first time
Hold the test strip briefly (for one second) under flowing
mains water. Shake off the water.
Wait for about 1 minute.
You will then be able to read the degree of water hardness
from the discolouration of the Aquadur
®
test strip and the
description on the packaging.
You can now adjust the water hardness.
Example: To change the water hardness from
16° dH
to
25° dH
, proceed as follows:
Precondition:
READY
appears on the display.
M l Keep the Rotary Switch pressed until,
RINSE
appears
on the display.
Ä l Turn the Rotary Switch until
HARDNESS -
is dis-
played.
M l Press the Rotary Switch to enter the programme item.
16° dH
appears on the display.
Ä l Turn the Rotary Switch until
25° dH
is displayed.
m l Press the Rotary Switch to confirm the setting.
OK
appears briefly on the display to confirm that the
water hardness is set.
HARDNESS
Ä l Turn the Rotary Switch until
EXIT
appears.
m l Press the Rotary Switch to exit programming mode.
READY
appears on the display.
You can adjust the grinder to suit the roast of your coffee.
Our recommendations:
Select a fine setting for a light roast.
Select a coarse setting for a darker roast.
If you adjust the fineness of grind when the grinder is not oper-
ating, the fineness of grind switch could be damaged.
Only adjust the fineness of grind when the grinder is run-
ning.
l
l
l
p
p
l
Adjusting grinder Adjusting grinder
CAUTIONCAUTION
To Next Page
Loading...
