10
Press any of the product keys to stop the frothing and the
brewing process prematurely.
The milk system is rinsed automatically 10 minutes after dis-
pensing milk. You will hear an acoustic signal before the rinsing
cycle starts.
10.4 Frothing milk
COFFEE READY
䡲 Place a cup under the height-adjustable dual spout (Fig. 6) and
press the Frothing key (Fig. 1/H). Make sure the milk hoses (Fig. 8/A)
have been dipped into the milk.
MILK FROTH
䡲 Your milk/frothed milk will be prepared.
A bargraph indicates the duration of the frothing process.
Press the frothing hos to stop the frothing process prema turely.
10.5 2x key
You can make 2 coffees in one brewing step by preselecting the
2x key. Press the 2x key and then the coffee key of your choice.
The milk products cannot be doubled.
COFFEE READY
䡲 Make 2 ristretti, espressi or coffees by pressing the 2x key (Fig. 1/D)
first.
COFFEE READY
䡲 Select a coffee product. For example, ristretto (Fig. 1/C)
2 RISTRETTI
䡲 The machine will now make two ristrettos in one brewing step.
11. Making hot water
COFFEE READY
䡲 Place a cup under the pivoting hot water spout (T) and press the
Hot Water key (T/ ).
HOT WATER
䡲 The machine stops dispensing the programmed portion of hot
water automatically.
A bargraph indicates the duration of the hot water dispensing
process.
To stop the machine from dispensing hot water prematurely,
press any of the product keys.
There might be some initial splashing when drawing off hot
water. The pivoting hot water spout becomes hot. Avoid direct
contact with the skin!
12. Drawing off steam
COFFEE READY
䡲 Place a cup under the pivoting steam spout (V) and press the
Steam key (S / ).
STEAM
䡲 The machine stops dispensing the programmed portion of steam
automatically.
A bargraph indicates the duration of the steam dispensing
process.
To stop the machine from dispensing steam prematurely, press
any of the product keys.
There might be some initial splashing when drawing off steam.
The pivoting steam spout becomes hot. Avoid direct contact
with the skin!
13. Switching the machine off
COFFEE READY
䡲 Switch the machine off using the ON / OFF key (Fig. 5/A). The
machine automatically performs a rinsing cycle when you switch it
off. Only the spouts and nozzles that were used are rinsed.
GOOD-BYE
Use the power switch on the rear of the machine (Fig. 15/D) to
disconnect the machine from the mains supply.
If cappuccino cleaning has been omitted following use of the milk
system, the following message appears in the display:
CLEAN MILK SYSTEM
CLEAN CAPPU.
START
YES
䡲 To perform milk cleaning as specified in section 16.10, press the P
button or the Milk Cleaning button (Fig. 5/H), or press the ‘+’ or ‘–’
button until the following appears in the display:
CLEAN CAPPU.
START
N0
䡲 To definitely switch the machine off without milk cleaning, press
the P button.
GOODBYE
If milk products are being dispensed, milk cleaning should be
performed on a daily basis.
DURATION
APPROX 2’
To Next Page
Loading...
