Jura IMPRESSA X9 - Setting up the Display

14
䡲 Press the ‘+’ or ‘–’ key to select the next program step or press EXIT
(Fig. 5/K) to leave programming mode.
䡲 Press EXIT (Fig. 5/K) again to leave programming mode.
14.9 Setting up the display
14.9.1 Unit of measurement (ml/oz)
This setting allows you to select a unit of measurement (ml or
oz).
COFFEE READY
䡲 Press P (Fig. 5/E) until you hear an acoustic signal.
HARDNESS
䡲 Press the ‘+’ or ‘–’ key until DISPLAY appears on the display.
SETTINGS
䡲 Press P again (Fig. 5/E) to activate the DISPLAY programming step.
SETTINGS
UNIT
ML
䡲 Press P again (Fig. 5/E) to activate the selected unit of measure-
ment.
SETTINGS
UNIT
ML
䡲 Press the ‘+’ or ‘–’ key to select the required unit of measurement.
SETTINGS
UNIT
OZ
䡲 Press P to confirm your setting (Fig. 5/E).
CONFIRMED
SETTINGS
UNIT
ML
䡲 Press the EXIT key (Fig. 5/K) for with ‘+’ or ‘–’ key to select the next
program step.
䡲 Press EXIT (Fig. 5/K) again to leave programming mode.
14.9.2 Time format
This setting allows you to select the time format (24 hours
or AM/PM).
COFFEE READY
䡲 Press P (Fig. 5/E) until you hear an acoustic signal.
HARDNESS
䡲 Press the ‘+’ or ‘–’ key until DISPLAY appears on the display.
SETTINGS
䡲 Press P again (Fig. 5/E) to activate the DISPLAY programming step.
SETTINGS
UNIT
ML
䡲 Press the ‘+’ or ‘–’ key until TIME FORMAT appears on the graphics
display.
SETTINGS
TIME
FORMAT
䡲 Press P again (Fig. 5/E) to activate TIME FORMAT.
SETTINGS
FORMAT
24 HRS
䡲 Press the ‘+’ or ‘–’ key to select the required time format.
SETTINGS
FORMAT
AM/PM
䡲 Press P to confirm your setting (Fig. 5/E).
CONFIRMED
SETTINGS
TIME
FORMAT
䡲 Press the EXIT key (Fig. 5/K) for with ‘+’ or ‘–’ key to select the next
program step.
䡲 Press EXIT (Fig. 5/K) again to leave programming mode.
14.10 Switch-on rinse
If the rinse start is set to AUTOMATIC, a rinse is automatically
initiated after every cold start. If the rinse start is set to
MANUAL, the rinse always has to be initiated by pressing the
Rinse button (Fig. 5/G).
COFFEE READY
䡲 Hold the P button (Fig. 5/E) down until an auditory signal is heard.
HARDNESS
䡲 Press the ‘+’ or ‘–’ button until RINSING MANUAL appears in the
display.
RINSING
MANUAL
䡲 To activate the RINSING programming step, press the P button
(Fig. 5/E) again.
RINSING
MANUAL
䡲 You can choose between manual and automatic rinse start by
pressing the ‘+’ or ‘–’ button.
RINSING
AUTO-
MATIC
To confirm the setting, press the P button (Fig. 5/E).
CONFIRMED