Jura IMPRESSA X9 - Maintenance; Filling the Water Tank; Emptying Coffee Grounds Container

15
E
RINSING
AUTO-
MATIC
䡲 To exit Programming mode, press the EXIT button (Fig. 5/K).
14.11 Information
With the IMPRESSA X9 you can check each coffee you made.
You can also check the number of cleaning cycles, decalcifying
cycles and Claris filter replacements you performed.
14.11.1 Information draw-off
COFFEE READY
䡲 Press P (Fig. 5/E) until you hear an acoustic signal.
HARDNESS
䡲 Press the ‘+’ or ‘–’ key until INFORMATION appears on the display.
INFORMATION
䡲 Press P (Fig. 5/E) to activate the INFORMATION programming step.
TOTAL
XXXXX
PRODUCTS
䡲 Press the ‘+’ or ‘–’ key to select the required item of infor mation.
14.11.2 Maintenance information
Maintenance information is requested in a similar way to
enquiring how many coffees have been dispensed.
COFFEE READY
䡲 Hold the P button (Fig. 5/E) down until an auditory signal is heard.
HARDNESS
䡲 Press the ‘+’ or ‘–’ button until INFORMATION appears in the dis-
play.
INFORMATION
䡲 To activate the INFORMATION programming step, press the P but-
ton (Fig. 5/E) again.
TOTAL
XXXXX
CUPS
䡲 To enquire how many times coffee cleaning, descaling, change of
filter or cappuccino cleaning have been performed or to check the
current maintenance status, press ‘+’ or ‘–’.
DECALCIFYING
䡲 To exit Programming mode, press the EXIT button (Fig. 5/K).
15. Counter
The single counter allows you to record your consumption over
a defined period of time. This counter can be reset to 0 at any
point in time.
COFFEE READY
䡲 Press Counter (Fig. 5/D) until you hear an acoustic signal.
1 ESPRESSO
150
PRODUCT
䡲 Press the ‘+’ or ‘–’ key to select a product.
䡲 The display will indicate the number of times this product was
made.
䡲 Press EXIT (Fig. 5/K) to leave the COUNTER.
Reset counter:
COUNTER
RESET
NO
䡲 Press the ‘+’ or ‘–’ key until the display indicates
COUNTER
RESET
YES
䡲 Press P to confirm your selection (Fig. 5/E).
RESET
16. Maintenance
16.1 Filling the water tank
WATER TANK
FILL
䡲 If this message is displayed, the machine will no longer make
coffee/hot water. Refill water as described in Chapter 3.3.
The water tank should be rinsed out and filled with fresh water
daily. When using a fixed water supply system, we recommend
regularly rinsing the water tank and filling it with fresh water.
16.2 Installing a fixed water supply system
Please refer to the operating instructions for the fixed water supply
system or contact your JURA dealer.
16.3 Emptying the coffee grounds container
The coffee grounds container collects the coffee grounds.
GROUNDS
EMPTY
䡲 If this information is displayed, the machine will no longer make
coffee. The grounds container needs to be emptied.
䡲 Carefully take out the drip tray; it is filled with water. Remove the
grounds container (Fig. 9/ A).
16.4 Emptying the drip tray
DRIP TRAY
EMPTY
䡲 If this information is displayed, the machine will no longer make
coffee. The drip tray needs to be emptied.
䡲 Carefully take out the drip tray; it is filled with water (Fig. 9/B).