Jura WE8 - Adjusting the product settings

24
4 Permanent settings in programming mode
In the programme item ‘Expert mode’ you can make individual set-
tings for all speciality coffees and hot water. The following perma-
nent settings can be made:
Product Coffee strength Amount Temperature
‘Ristretto’,
‘Espresso’
8 levels Coffee: 15ml–80ml normal, high
‘Coffee’ 8 levels Coffee: 25ml–240ml normal, high
‘2 ristretti’,
‘2 espressi’,
‘2 coffees’
– Coffee: The amount set for
the single product is doubled.
as for single product
‘Flat white’ 8 levels Coffee: 25ml–240ml
Milk: 3sec.–120sec.
normal, high
‘Cappuccino’,
‘Latte macchiato’
8 levels Coffee: 25ml–240ml
Milk: 3sec.–120sec.
Interval: 0sec.–60sec.
normal, high
‘Milk foam’ – Milk: 3sec.–120sec. –
‘Hot water’ – Water: 25ml–450ml low, normal, high
Permanent settings in programming mode always follow the same
model.
Example:Proceed as follows to change the coffee strength for one
coffee.
T Press the
‘Pc’ button.
T Press the
‘>’ button several times until ‘3/6’ is displayed.
T Press the
‘Expert mode’ button.
‘Expert mode’
E Next select the button of the product for which you would like
to make settings. No product is prepared at this point.
E To display more products, press the
‘>’ button (bottom right).
T Press the
‘Coffee’ button.
‘Coffee’
T Press the ‘Coffee strength’ button.
‘Coffee’ and the coffee strength is displayed.
T Press the
‘<’ or ‘>’ button to change the setting for the cof-
fee strength.
Adjusting the product
settings