6 Machine settings
23
6 Machine settings
Press the Rotary Switch to open the Cockpit. In the ‘Machine setting’ f section, you can make the
following settings:
Program item Explanation
‘Smart mode’ Arrange products by preparation frequency on the start screen after a certain
amount of time (the h symbol in the Cockpit shows that ‘Smart mode’ is
activated)
‘Product name’ Display product images with/without product names on the start screen
‘Add start
screen’
Define number of start screens (–)
‘Number of
products’
Set the number of products on the start screen: products, products or
automatic (‘Smart mode’)
‘Wi-Fi
connection’
Wirelessly connect your Z with your JURA app (J.O.E.
®
) or with the Cool
Control milk cooler, or disconnect again (see chapter ‘Preparing and using
for the first time – Establishing a WiFi connection’)
‘Switch off after’ Set the automatic switch-off time to save energy (switch-off after minutes,
minutes or – hours after the last action on the machine)
‘Choose
language’
Set language
‘Factory setting’ Restore factory settings (your Z will switch off after this)
‘Water hardness’ Set the hardness of the water used (°dH to °dH) to prevent calcification of
your machine.
‘Units’ Set the unit for the amount of water (ml or oz)
‘Information’ View software version
‘Connect
accessory’
Wirelessly connect your Z with your JURA app (J.O.E.
®
) or with the Cool
Control milk cooler, or disconnect again
‘Display’ Change display brightness (in % increments)
‘Empty system’ Empty the system to protect the Z from frost during transport (see chapter
‘Transport and environmentally friendly disposal – Transport/ Emptying the
system’)
‘Product
counter’
View product counter
‘Maintenance
counter’
View the maintenance counter
To Next Page
Loading...
