Jura Z10 - Dual Spout Maintenance

7 Maintenance
26
T
 Place the container under the dual spout and connect the milk
pipe with the container.
E To connect the milk pipe to the container correctly, the pipe
must be fitted with a connector.
T
 Slide the dual spout down to fix the container in place.
T
 Touch ‘Start’.
The dual spout and the milk pipe are cleaned.
The operation stops automatically.
If insufficient foam is produced when the milk is frothed or milk
sprays out of the dual spout, the frother may be clogged. If this
happens, dismantle and rinse the dual spout.
T
 Remove the milk pipe and rinse it thoroughly under running
water.
T
 Press the releasing devices and pull the cover of the dual spout
up and off.
T
 Remove the milk system from the dual spout.
E Do not lever the milk system back and forth to disconnect it
from the milk pipe connection. Remove the milk system
firmly to prevent it from tilting.
T
 Dismantle the milk system into its individual parts.
T
 Rinse all the parts under running water. If there are severely
dried-on milk residues, first immerse the individual parts in a
solution of . oz (ml) water and one dose of JURA milk
system cleaner. Then rinse the individual parts thoroughly.
6
Dismantling and rinsing the
dual spout