Jura Z8 - Connecting Milk

14
1 Preparing and using for the first time
Milk, sparkling mineral water or other liquids can damage the water
tank or the machine.
T Only fill the water tank with fresh, cold water.
T Touch
‘No filter’.
‘Descaling mode’ / ‘Saved’
‘Fill water tank’
T Place a receptacle under the dual spout and the hot-water
spout.
T Remove the water tank and rinse it with cold water.
T Fill the water tank with fresh, cold water and reinsert the
tank.
‘System is filling’, water flows out of the dual and hot-water
spout.
‘Machine is heating’
‘Machine is rinsing’
, the system is rinsed. The rinse stops
automatically. The start screen is displayed. Your Z8 is ready
for use.
Your Z8 creates fine, creamy, feather-light milk foam with a perfect
consistency. The most important requirement for frothing milk is a
milk temperature of 4–8°C. We would therefore recommend using
a milk cooler or a vacuum milk container.
T Connect the milk pipe to the dual spout.
T Connect the other end of the milk pipe to a milk container
or a milk cooler.
First-time use without filter
cartridge activation
CAUTION
Connecting milk