Jura Z8 - Adjusting the Grinder

20
2 Preparation
T Fit the filler funnel for ground coffee.
T Place one level measuring spoon of ground coffee into the
filler funnel.
T Remove the filler funnel and close the cover of the powder
chute.
‘Please select product’
T Touch ‘Espresso’.
Preparation starts.
‘Espresso’appears and the preset amount
of water for espresso flows into the cup.
Preparation stops automatically. Your Z8 is once more ready
for use.
You can adjust the grinder on a continuous scale to suit the degree
of roast of your coffee.
If you adjust the consistency of grind when the grinder is not oper-
ating, the grinder adjustment switch could be damaged.
T Only adjust the consistency of grind when the grinder is run-
ning.
The consistency of grind is correct if the coffee flows regularly from
the coffee spout. In addition a fine, thick crema forms.
Example: Proceed as follows to change the consistency of grind
during the preparation of an espresso.
Precondition:The start screen is displayed.
T Place a cup under the coffee spout.
T Open the cover of the grinder adjustment switch.
T Touch
‘Espresso’ to start preparation.
T Turn the grinder adjustment switch to the desired position
while the grinder is running.
The preset amount of water flows into the cup. Preparation
stops automatically.
T Close the cover of the grinder adjustment switch.
Adjusting the grinder
CAUTION