Jura Z8 - Unit for Amount of Water; Display Settings

30
4 Permanent settings in programming mode
In the programme item ‘Machine settings’/ ‘Units’ you can select
the unit used for the amount of water.
Example:Proceed as follows to change the unit for the amount of
water from
‘ml’ to ‘oz’.
Precondition:The start screen is displayed.
T Touch
‘P’.
‘Machine settings’
T Touch ‘Machine settings’.
‘Switch off after’
T Move your finger across the display until ‘Units’ is displayed
in the centre.
T Touch
‘Units’.
‘Units’
T Now move your finger to the left or right to change the set-
ting to
‘oz’.
T Touch
‘Save’.
‘Saved’ appears briefly on the display.
‘Units’
T Touch ‘Back’ the number of times needed to display the start
screen again.
In the programme item
‘Machine settings’/ ‘Display’ you can set the
display brightness (as a percentage).
Precondition:The start screen is displayed.
T Touch
‘P’.
‘Machine settings’
T Touch ‘Machine settings’.
‘Switch off after’
T Move your finger across the display until ‘Display’ is dis-
played in the centre.
T Touch
‘Display’.
‘Display’
T Now move your finger to the left or right to change the set-
ting.
T Touch
‘Save’.
‘Saved’ appears briefly on the display.
‘Display’
Unit for amount of water
Display settings