Jura Z8 - Setting the Water Hardness; Language

31
4 Permanent settings in programming mode
T Touch ‘Back’ the number of times needed to display the start
screen again.
The harder the water is, the more frequently the Z8 needs to be
descaled. It is therefore important to set the water hardness accu-
rately.
The water hardness was set when the machine was first used. You
can change this setting at any time.
The water hardness can be adjusted on a continuous scale between
1°dH and 30°dH.
Precondition:The start screen is displayed.
T Touch
‘P’.
‘Machine settings’
T Touch ‘Machine settings’.
‘Switch off after’
T Move your finger across the display until ‘Water hardness’ is
displayed in the centre.
T Touch
‘Water hardness’.
‘Water hardness’
T Now move your finger to the left or right to change the set-
ting.
T Touch
‘Save’.
‘Saved’ appears briefly on the display.
‘Water hardness’
T Touch ‘Back’ the number of times needed to display the start
screen again.
In this programme item you can set the language used by your Z8.
Example:Proceed as follows to change the language from
‘English’
to
‘Deutsch’.
Precondition:The start screen is displayed.
T Touch
‘P’.
‘Machine settings’
T Touch ‘Machine settings’.
‘Switch off after’
T Move your finger across the display until ‘Choose language’
is displayed in the centre.
Setting the water
hardness
Language