Jura Z8 - Water Tank Illumination

32
4 Permanent settings in programming mode
T Touch ‘Choose language’.
‘Choose language’
T Move your finger across the display until the desired lan-
guage, e.g.
‘Deutsch’, is displayed in the centre.
T Touch
‘Save’.
‘Gespeichert’ appears briefly on the display.
‘Sprachauswahl’
T Touch ‘Zurück’ the number of times needed to display the
start screen again.
In the programme item
‘Machine settings’ / ‘Water tank illumina-
tion’
you can change the setting for water tank illumination:
U
‘Permanent’: The water tank is always illuminated.
U
‘Temporary’: The water tank is only illuminated when a prod-
uct is being prepared.
Example:Proceed as follows to change the water tank illumination
from
‘Permanent’ to ‘Temporary’.
Precondition:The start screen is displayed.
T Touch
‘P’.
‘Machine settings’
T Touch ‘Machine settings’.
‘Switch off after’
T Move your finger across the display until ‘Water tank illumi-
nation’
is displayed in the centre.
T Touch
‘Water tank illumination’.
‘Water tank illumination’
T Now move your finger to the left or right to change the set-
ting to
‘Temporary’.
T Touch
‘Save’.
‘Saved’ appears briefly on the display.
‘Water tank illumination’
T Touch ‘Back’ the number of times needed to display the start
screen again.
Water tank illumination