Juuko HS-K800 series - Troubleshooting; Transmitter Troubleshooting; Receiver Troubleshooting; Basic Installation Instructions

8
Chapter 4: Failure Analysis and solution
HS-K800 series
Radio remote control system
BASIC INSTALLATION INSTRUCTIONS
(English)
Standard settings
- Stain on the battery
springs.
- Low battery.
- Transmitter is not
communicated with
receiver.
- Push button damaged.
-Clean the stains on battery
springs
.
- Replace brand new
batteries.
- Check the power supply
of receiver.
-
Check receiver’s fuse.
- Contact the dealers.
LED Signal Failure Analysis
Solution
LED red LED green
LED red LED green
SHORT
LONG
LED red LED green
Troubleshooting
Transmitter
Receiver
Should an error occur, LED of the receiver unit will indicate the cause of the error.
-RF error
-
Receiver is not powered.
-Check the antenna and
make sure it is not loose.
-Contact dealer
-
Change the fuse.
-Check the power supply.
LED Signal Failure Analysis
Solution
LED red LED green
SHORT
LONG
LED red LED green
LED red LED green
Valid data or Invalid data (from a dierent transmitter)
received.