JVA ELECTRIC FENCE SYSTEMS
32
[1] [#]. Information may be entered into the keypad in the form of letters (upper
and lower case), numbers (0–9), and 22 special symbols. All characters are
displayed in the order: upper and lower case letters, numbers, and special
symbols. The [Space] character precedes the letter A.
the desired character. If you scroll past the desired character, the [8] key may be
used to scroll backwards. NOTE: The space character is before the A character
(When A is displayed, press [8] to get a space).
the next character position. The [4] key moves the cursor to the left.
and move to the next message position.
NOTE: If you move to the next message using [5] instead of the [#] key you will lose
any changes you made!
To change the keypad address, scroll through the messages until the keypad
displays: “Keypad address __” then change the value by pressing [2] (up) or [8]
(down). Validate by pressing [#].
The message order is:
DEALER MESSAGE (Displayed under the standby message: “Ready to Arm”)
ZONE NAMES
BAUD RATE (should be left at 2400)
KEYPAD ADDRESS ((should be left at 1)
8.2 To Exit Keypad Programming
NOTE: The keypad will also exit the programming mode if you do not press any key
To return the Keypad to default settings press the emergency button during
JVA Z114 LCD Keypad Features
To Next Page
Loading...
Need help?
General
