7
During recording, the indications do • Press DISPLAY for longer than 1 second to make tile
not appear, indications appear (_:T_ pg. 15).
The tape will not eject. • Tile battery pack is running low.
• If the LCD mr)nitor is not open over 60 degrees, the ELECT
Switch does not function.
Some functions are not available. • Tile Power Switch is set to "AUTO".
• Certain combinations of modes or effects are not possible
to use.
Vertical white lines appear when
shooting a very bright object.
• This sometimes occurs when tile contrast between tile
bacl<ground and the object is great. It is not a defect of the
cal_lcorder.
Bright, crystal-shaped spots appear in • Sunlight is directly entering tile lens. This is not a defect of
the [CD monitor and the viewfinder, the camcorder.
The rear of the LCD monitor is hot.
• Tile light used to illuminate tile LCD monitor causes it to be
hot. Close the LCD monitor to turn it off or set the Power
Switch to "OFF", and let the unit cool down.
Colored bright spots appear all over
the LCD monitor or the viewfinder.
• Tile LCD monitor and tile viewfinder are made with high-
i)recision technology. However, black spots (11 bright s[)r)ts
of light (red, green or blue) may a ) )ear constantly on the
LCD mr)nitor or in the viewfinder. These spots are not
recorded on the ta )e. This is not due to any defect of the
unit. (Effective c ors: more tlan 99.99 %.
The indicators and the picture color
on the LCD monitor are not clear.
The LCD monitor, the viewfinder and
the lens have become dirty rex.
fingerprints).
The picture is blurred in the Quick
Review or Retake mode.
• This may occur when tile surface or tile edge of tile LCD
monitor is pressed.
• Wi )e them gently with a soft cloth. Gently wi )e in a
semicircular motion, as wi )ing strongly s )reads the stain
ant it won't come out easi y.
• This is normal while recording in tile EP mode. Some noise
may be present while recording in the SP mode (_:T_ pg. 12).
An error number (i.e. E03) appears. • Turn the camcorder's power off, then disconnect the power
source. After a few minutes, try turning the power on again.
If tile error number still al)pears in the\'iewfindet_ consuh
your nearest JVC: dealer.
The image is out of focus.
The date and time displays
disappear.
o Tile diopter needs to be adjusted (_-:_ pg. 13).
• The scene being shot is adversely affecting the ol)eration of
Auto Focus (_:V_ pg. 28).
• If you remove tile power source from tile camcorder while
the power is on, all settings and selections are erased. Make
sure to turn the camcorder's power off before disconnecting
tile power S(/urce.
The wrong date and time are
displayed/recorded.
Even though the lens cover is open,
the Lens Cover Warning indicator
blinks.
• fy { lave 1 t pefor_/ec Date/T _/e Sett /g(_-T_pg 11),
the date and time are not displayed/recorded correctly. Be
sure that Date/Time setting is carried out.
• Tile Lens Cover Warning indicator may blinl< when tile
camcorder is used in darl< areas, regardless of tile position
of the lens cover.
To Next Page
Loading...
