indicationsDuri.gPlayback
EN41
(_ Cassette Indicator
Displayed when a tape is loaded.
_ TB( Indicator ...................................... _T* pg. _1
_ Tape Counter. ...................................... _T* pg. _1
(_ Recording Mode Indicator (SP/EP) ........ _T* pg. 12
_ Tape Running Indicator
I_ : Playback
I_1_ : Fast-Forward/Shuttle Search
: Rewind/Shuttle Search
Hi[ : Pause
_ Tracking Indicator ................................ _-z_ pg. 31
_7_ * BRIGHT: Bright Level Indicator .......... _-z_ pg. 30
VOLUME: Speaker V_lume
Indicator ........................................... _-z_ pg. 30
War.i.g indications
[ndications Fundion
rTa
TAPE END
LENS COVER
CONDENSATION
PLEASE WAiT
TAPE HEAD iS DIRTY
USE CLEANING
CASSETTE
E01 -- E06
SAFEGUARD FUNCTION
HAS BEEN ACTIVATED
REATTAC H BATTERY
Displays the battery remaining power.
Remaining power [evel: high. it does not necessarily mean that the battery
pack is fully charged. "::_-C]_]-C:_]-CZ_]
/
Remaining power level: exhausted
As the battery power comes close to nil, the battery indicator CZZ3 blinks
(battery power warning).
When the battery power is exhausted, power turns off automatica[ly.
Blinks when no cassette is loaded, or when the Erase Protection tab is not in
the position that allows recording. (; y pg. 10)
Blinks for approx. 10 seconds when the power is turned on. This display also
blinks when the dock dithium) battery is either not installed or has discharged.
install or replace the old battery with a new one. (; _- pg. 10)
Appears when the tape ends during recording, playback or fast-forward.
(;y pg. 15)
Blinks for approx. 5 seconds when the camcorder is turned on with the lens
cover dosed. (_ y pg. 14)
These 2 warnings appear a[temately every 3 seconds if condensation occurs, mnthis
case,all functions except tape eiect and power on/off are disabled. Turn the unit off
(without removing the power supply), wait a few minutes for the warnings to clear,
and turn it on again.
These 2 warnings appear alternately every 3 seconds if dirt is detected on the
heads during recording. In this case, use an optional cleaning cassette. If the
warning remains after cleaning, consult your nearest IVC dealer.
The error indications (E01 -- E06) show what type of malfundion has occured.
If an error indication and warning appear, turn the unit off, remove the power
supply (battery, etc.) and wait a few minutes for them to clear. When it does,
you can resume using the camcorder. If the indication remains, consult your
nearest IVC dealer.
To Next Page
Loading...
