—4—
[Choose Destination Location] screen
appears.
6 Click [Next].
[Select Working Directory] screen
appears.
7 Select the Working Directory
and click [Next].
[Select Program Folder] screen
appears.
8 Click [Next].
[Setup will install...] screen appears.
9 Click [Next].
Wait for a moment until the installation
is finished.
When the installation is finished,
[Setup Complete] screen appears.
For Windows
®
98SE/Me/2000:
Before [Setup Complete] screen
appears, [Question] screen appears.
Click [Yes]. Then, [DMA setting] screen
appears. Click [OK]. [Setup Complete]
screen appears.
10 Click [Finish].
Then, CyberLink PowerProducer
Readme file and its registration screen
appear.
● Be sure to read the Readme file.
● To receive the customer support
service and product information, fill
in and submit the user registration.
NOTE:
If you perform installation of a software that
is already installed, uninstallation will start.
In this case, perform the installation again
after uninstallation is finished.
To Next Page
Loading...
