GETTING STARTED
12 EN
MasterPage: Left
How To Attach The Core Filter
Attach the core filters to the cables. The core
filter reduces interference.
1 Release the stoppers on both ends of the
core filter.
2 Run the cable through the core filter, leaving
approx. 3 cm (1-3/16") of cable between the
cable plug and the core filter.
Wind the cable once around the outside of the
core filter as shown in the illustration.
3 Close the core filter until it clicks shut.
NOTES:
● Take care not to damage the cable.
● When connecting a cable, attach the end with the
core filter to the camcorder.
Stopper
3 cm (1-3/16")
Wind once.
Core filter
GR-D290_270US.book Page 12 Tuesday, November 30, 2004 9:53 AM
To Next Page
Loading...
