JVC GR DVL 200 - Dubbing Images Stored in the Built-In Memory to a Tape

46 EN
P
L
A
Y
O
F
F
T
P
O
US
C
H
OP
S
Y
TA
T
R
O
T/
T
S
A
T
P
O
E
P
R
4
E
4
C
4
Power Switch
Rewind Button (
2 )
Fast-Forward
Button (
3 )
Lock Button
Dubbing Images Stored In The Built-in
Memory To A Tape
Images can be dubbed from the camcorder’s built-in
memory to a tape.
1
Load a cassette ( pg. 10).
2
To locate the point where you wish to dub a still
image, play back the tape. Stop playback at the
desired point.
3
2
Set the VIDEO/DSC Switch to “ ”, then set the
Power Switch to “ ” while pressing down the
Lock Button located on the switch.
4
3
To select a still image to be dubbed, perform Index
Playback ( pg. 35) or press 2 or 3 to select the
image you wish.
5
To engage Dub-Standby, press the Recording Start/
Stop Button. The message “TO COPY TO TAPE PUSH
START/STOP” appears.
6
While the message is being displayed, press the
Recording Start/Stop Button. The selected still image
is recorded on the tape for approx. 5 seconds.
•The indicator disappears when dubbing is
complete.
NOTE:
If the Recording Start/Stop Button is pressed in step 5 when
the tape’s erase protection tab is set to “SAVE”, the
message “COPYING FAILED” is displayed.
Display
DUBBING (cont.)
Recording
Start/Stop Button
VIDEO/DSC Switch (Open the
LCD monitor to access this switch.)