JVC GR DVL 200 - Dubbing Images Recorded on a Tape to the Built-In Memory

EN47
SP 6
1
S
1
S
R
R
O
2
Y
E
E
U
B
N
C
V
T
N
I
C
I
U
D
T
H
M
D
R
R
O
E
N
M
M
O
D
C
O
O
O
E
O
D
D
P
M
E
E
Y
EN
O
U
N
P
L
A
Y
O
F
F
Play/Pause Button ( 4 /6)
Display
Power Switch
SNAPSHOT Button
Lock Button
Dubbing Images Recorded On A Tape To
The Built-in Memory
Images can dubbed from a tape to the camcorder’s built-in
memory.
1
Load a cassette ( pg. 10).
2
Set the VIDEO/DSC Switch to “VIDEO”, then set the
Power Switch to “ ” while pressing down the
Lock Button.
3
Press MENU/BRIGHT. The Menu Screen appears.
Rotate it to select “ ” and press it. “VIDEO MENU”
appears.
4
Rotate MENU/BRIGHT to select “ COPY”
and press it. The Sub Menu appears. Rotate it to
select “ON” and press it. Selection is complete.
5
Rotate MENU/BRIGHT to select “ 1 RETURN” and
press it twice. The normal playback screen resumes.
6
To select a video image to be dubbed, start playback
by pressing 4 /6. At the moment you find the image
you wish to dub, press it again to engage Still
Playback.
7
Press MODE to select the Snapshot mode to use for
dubbing the image to the built-in memory.
8
To start dubbing, press SNAPSHOT. The selected
image is stored in the built-in memory.
•“ ” blinks during dubbing.
NOTES:
● If SNAPSHOT is pressed in step 8 when the built-in
memory is full, the message “COPYING FAILED”
appears.
● If an image recorded on the tape using the WIDE mode
(  pg. 24) is dubbed to the camcorder’s built-in
memory, the WIDE mode identifying signal is not
dubbed with it.
● To use Playback Special Effects with a video image you
wish to dub, perform up to step 8 using the remote
control (provided) (  pg. 51).
MENU/
BRIGHT
Wheel
VIDEO/DSC Switch (Open the
LCD monitor to access this switch.)
MODE Button