JVC GR-DX series - 1.2.2 Cabinet and Electrical Parts Disassembly

(No.YF009)1-3
1.2.2 ASSEMBLY/DISASSEMBLY OF CABINET PARTS AND ELECTRICAL PARTS
zDisassembly procedure
NOTE 3a:
Open the CASSETTE COVER, and remove the two screws
(No.7 and 8).
NOTE3b:
Take care not to cut the FPC and wire.
NOTE3c:
Be careful about the HOLDER (DV/USB) because it is
removed together with the FRONT COVER ASSY.
NOTE5a:
Take care not to damage the part.
NOTE5b:
Take care not to cut the FPC.
NOTE6a:
Remove the MIC wire while removing the MAIN BOARD
ASSY.
NOTE6b:
Take care not to cut the FPC.
NOTE8:
Take care not to damage the LENS in OP BLOCK ASSY
and not to cut the FPC.
NOTE10:
Take care not to cut the FPC.
zDestination of connectors
Step
No.
Parts Name
Fig.
No.
Point Note
[1]
[2]
[3]
[4]
[5]
[6]
/[7]
[8]
/[9]
[10]
COVER(TOP)
COVER(MIC)
FRONT COVER ASSY
COVER(DV)
UPPER ASSY
MAIN BOARD ASSY
/MECHANISM ASSY
OP BLOCK ASSY
/MIC ASSY
VF ASSY
(S1a),3(S1b),2(L1)
L2
2(S3a),(S3b),(S3c),(S3d),CN3,HOLDER(DV/USB)
(S4a),(S4b)
(S5a),(S5b),2(S5c),(S5d),(S5c),
(S5d),(S5e),CN5a,CN5b
CN6a,b,c,d,e,(S6a),3(S6b),2(S6c),
L6a,SHELD PLATE,L6b,CN6f,g,h,i,k,m
(S7a),3(S7b),BKT(PRE/REC),MECHA BKT ASSY
(S8),BKT(TOP),L8,CN8
CN10,2(S10)
Fig.C1
Fig.C2
Fig.C3
Fig.C4
Fig.C5-1
Fig.C5-2
Fig.C6
Fig.C7
-
-
NOTE3a,b,c
-
NOTE5a,b
NOTE6a,b
-
NOTE8
NOTE10
CN No.
CONNECTOR
Pin.
No.
CN3 MAIN CN115 STROBE CN6501 12
CN5a MAIN CN113 MONITOR CN7601 49/45
CN5b MAIN CN112 SUB OPE UNIT - 9
CN6a MAIN CN101 BATT.TERM. - 17
CN6b MAIN CN109 SD CN301 60
CN6c MAIN CN102 CCD - 20
CN6d MAIN CN111 CAMERA OPE UNIT - 11
CN6e MAIN CN114 MIC - 4
CN6f MAIN CN106 SENSOR - 16
CN6g MAIN CN110 HEAD - 8
CN6h MAIN CN103 LOADING MOTOR - 6
CN6j MAIN CN107
ROTARY ENCODER SW - 6
CN6k MAIN CN104 DRUM MOTOR - 11
CN6m MAIN CN108 CAPSTAN MOTOR - 18
CN8 SD CN302 OP BLOCK ASSY - 24
CN10 SD CN304 VF BW CN7001 18