1-20 (No.YF016)
4.4.1.1 Tilt
(1) Put the deflection yoke to the most inner side of CRT neck
first. Then fix the stopper temporary.
(2) Adjust the tilt of picture on the E. VF screen by tilting the de-
flection yoke.
(3) Fix the stopper completely.
4.4.1.2 Centering
(1) While observing the viewfinder screen, adjust the centering
magnet to locate the stairstep in the center of the view-find-
er screen.
4.4.1.3 Vertical scanning
(1) Observing the viewfinder screen, adjust VR7001 for normal
picture amplitude.
4.4.1.4 Brightness
(1) Close the lens with the cap and adjust VR7002 so that the
raster of the CRT is just visible in the E. VF.
4.4.1.5 Focus
(1) While observing the viewfinder screen, adjust VR7003 so
that the picture at the central area of the screen is clear and
defined.
Subject • Alignment tape
•Stairstep
Mode • PB
Equipment • E. VF
Measurement point • E. VF screen
Adjusting part • Deflection yoke
Specification • The picture is visible as same as
monitor TV.
Subject • Alignment tape
•Stairstep
Mode • PB
Equipment • E. VF
Measurement point • E. VF screen
Adjusting part • Centering magnet
(CRT BOARD ASSEMBLY)
Specification • The center of the E. VF screen
Subject • Camera picture
Mode • EE
Equipment • E. VF
Measurement point • E. VF screen
Adjusting part • VR7001 (V. SIZE)
Specification • Normal picture amplitude
Subject • -
Mode • EE
• Lens closed
Equipment • E. VF
Measurement point • E. VF screen
Adjusting part • VR7002 (BRIGHT)
Specification • The CRT raster is just barely visible
Subject • Camera picture
Mode • EE
Equipment • E. VF
Measurement point • E. VF screen
Adjusting part • VR7003 (FOCUS)
Specification • The center area is clear and defined
To Next Page
Loading...
