JVC HR-J635EK - Regular Timer Programming

30
Regula r Timer
Progra mming
If you don’t know the PlusCode number for the programme you
wish to record, use the following procedure to set your recorder
to timer-record the programme.
Or you can use the Illumi-Guide feature, where the remote
control tells you which button to press next by lighting it up. To
use the Illumi-Guide feature, press ILLU M I GU ID E before
performing step 1. (PRO G, REW , PLAY, FF light up at this time.)
If you aren't going to use the Illumi-Guide feature, go directly to
step 1.
12
45
3
6
8
0
7
9
2


1
3
START+/ –
PRO G.
2,3
1
W hen Using The Illumi-Guide Feature
● Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUM I GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press CAN CEL and re-perform the timer programming
procedure from the beginning.
● If for some reason the remote control's signal is not received
by the video recorder, press CANCEL and re-perform the
timer programming procedure from the beginning.
TIM ER RECORDING(cont.)
CANCEL
ILLUM I GUIDE
6
q
Remember, the clock must be set before you can progamme
the timer (Z pg. 9).
ACCESS TIMER PRO GRAM-
MING SCREEN
1
Press PROG.
● If you are using the Illumi-Guide feature, the following
buttons will light up: N U M BER keys (0–9), START +/ –,
STO P +/ –, DATE +/ –, TV PRO G +/ –, and CAN CEL.
ACCESS PRO GRAMME
SCREEN
2
Press START +/ –. (If you’re
just starting out, “ Program
1” appears.)
The front display panel looks like this:
● If you are using the Illumi-Guide feature, the following
buttons will light up: START +/ –, STOP +/–, D ATE +/–,
and TV PROG +/ –.
ENTER PRO GRAMME
START TIME
3
Press START +/ – to enter
the time you want
recording to start.
● Press and hold START
+/ – to move in 30-
minute increments, or
press and release
repeatedly to move 1
minute at a time.
The front display panel looks like this:
● If you are using the Illumi-Guide feature, the following
buttons remain lit: START +/ –, STOP +/ –, DATE +/ –,
and TV PROG +/ –.
SP
SP
PROGRAM 1
START STOP
– : – – – : – –
SP
ON
DATE TV PROG
25. 12 – –
[+ –] : SET =
:OK
PROGRAM 1
START STOP
21 : 00 – : – –
SP
ON
DATE TV PROG
25. 12 – –
[+ –] : SET =
:OK
Downloaded from: https://www.usersmanualguide.com/