52 EN
This Remote is capable of transmitting two control
codes; one set to respond to A code control signals and
another set to respond to B code control signals.
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily modify your VCR and the Remote
to respond to B code signals.
When using two JVC VCRs, set two VCRs and their
Remotes to different codes, so that you can operate these
VCRs separately.
1
Set remote control code for Remote
1
Press and hold A/B.
2
Press the Number key “2”.
3
Press OK, and release A/B.
● The Remote now can transmit B code control
signals.
2
Check remote control code for VCR
Press and hold 3 on the VCR for more than
5 seconds while the VCR is turned off. The code
currently set appears on the display panel.
3
Change code for VCR
Press any key on the Remote.
● The VCR now responds to B code control
signals.
● To set the Remote and the VCR back to A code
control signals, repeat the same procedure as
shown above except pressing the Number key
“1” in step
2
of
1
.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote
control code for the Remote between A and B (墌 step
1
), keeping two VCRs to different control codes.
● Press the Number key “1” for A code control signals
and the Number key “2” for B code control signals. (To
change only the remote control code for the Remote,
DO NOT perform steps
2
and
3
.)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
Press in succession
Hold
down
Release
123
456
7
89
0
2
4
1
3
1
–
2
1
–
3
1
–
1
,
3
MBR SET
A/B
2
OK
3
E
N
T
E
R
/
O
S
D
SP EP
VCR
PLAY
REW
FF
REC PAUSE STOP/EJECT
+
S-VHS ET
CH
REC LINK
VIDEO (MONO)L—AUDIO—R
2
MULTI-BRAND REMOTE CONTROL (cont.)
To Next Page
Loading...
