JVC HR-S5200U - Setting Up Your VCR; Making the Right Connections; RF Channel Selection

Setting Up Your VCR
Making the right connections
It's essential that your VCR be properly hooked up for proper results. Follow these steps carefully. THESE STEPS MUST BE COMPLETED
BEFORE ANY VCR OPERATION CAN BE PERFORMED.
IF YOU HAVE A STANDARD TV SET
[ RF CONNECTION “|
| -[t] Disconnect the TV antenna from the TV.
{2} Connect the TV antenna to'the VCR's ANTENNA-IN.
[3] Connect the VCR's: TV OUT to the TV's antenna terminal
. using the provided RF cable.
Antenna or Cable
Flat Feeder |
—=_= TT —
Coaxial Cable
AC Power
Cord (
ANTENNA-IN
(Antenna or
Cable input)
Tv OUT
* Back of VCR
AC-Outlet
RF Cable
(provided)
terminal
See the "Basic Guide For VCR Connections" sheet
enclosed with this instruction manual for more
information and other possible connections.
SELECT VCR CHANNEL (3 OR 4)
|
with
a
ed
RF
ae
Back
of
VCR
NOTES:
the
VCR’
sends
picture.and
‘sound
r
-
To
operate,
the
VCR
with
your
TV
using
an
RF
ry ‘to set your TV's
charinel to the oné you set the VCR to in this step.
a Even if your TV is connected using AV input
connectors, it is necessary to also connect your VCR
and TV using the RF cable if you ever wish to watch
a program while recording another (7 p. 25).
- signals’ through the co)
cable to your TV on channel 3 or
|, 4,The VCR's switch is pre-set to
‘|. €H3 prior to shipment. Set this
switch to CH4 in areas where
channel 3 is used for broadcasting.
EN-8
Or...
IF YOU HAVE ATV
WITH AV INPUT CONNECTORS
AV CONNECTION
(1) Connect the antenna, VCR and TV as per "RF
CONNECTION",
[2] Connect the VCR's AUDIO OUT and VIDEO OUT to the
TV's AV-IN connectors.
Antenna or Cable.
AC Power
_- ANTENNA-IN
(Antenna or Cable
input)
Tv OUT
AC Outlet
__ Video/Audio Cable (provide);
i VIDEO/AUDIO
: IN
ES RF SETTING IF
NECESSARY.
Even if: your Vi is contiected to AV input connectors, it is necessary
to also conitiect’ your VCR and TV using the RF cable if you ever
wish to watch a program | While as another (C¥ p.25).
_EN-9