advanced features 37
Editing
L-1 OUTPUT Setting
The L-1 IN/OUT connector delivers either a composite signal (regular video
signal) or a Y/C signal (a signal in which the luminance and chrominance signals
are separated). Set
L-1 OUTPUT to the appropriate mode depending on the type of
unit connected to the rear panel
L-1 IN/OUT connector of this VCR.
get to the output/input set screen Press . Move the highlight bar to
OUTPUT/INPUT SET using the
PR
and
PR
buttons and press (or E).
select mode Move the highlight bar to L-1
OUTPUT
using the
PR
and
PR
buttons. Press
(or E) to select the desired mode:
FOR L-1 OUTPUT
•
VIDEO : If a connected device’s input is
compatible only with regular
video signals, set to
VIDEO.
•
S-VIDEO : If a connected device’s input is
compatible with Y/C signals, set to
S-VIDEO. This setting will let you take advantage of higher-quality
S-VHS pictures. (For connection, be sure to use a 21-pin SCART
cable that is compatible with the Y/C signal.)
return to normal screen Press .
[1] a k
[MENU]: EXIT
OUTPUT/INPUT SET
L-1 OUTPUT VIDEO
L-2 INPUT VIDEO
F
HR-S5965/5966EK-EN/p27-40 2/19/03, 04:10 PM37
To Next Page
Loading...
