September 15, 2004 11:23 am Page 4
—4—
Master Page: Right
A Check contents
Make sure the package contains all of the accessories listed in
“Specifications” (
墌 19).
B Situate recorder
Place the recorder on a stable, horizontal surface.
C Connect recorder to TV
RF Connection
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANT. IN connector on the
rear of the recorder.
C Connect the provided RF cable between the RF OUT
connector on the rear of the recorder and the TV’s aerial
connector.
AV Connection
If your TV is equipped with a AV Input Terminals connector,
perform AV connection to improve picture quality during tape
playback.
A Connect the aerial, recorder and TV as shown in the
illustration.
B Connect an optional AV cable between the AUDIO OUT/
VIDEO OUT connector on the rear of the recorder and the
AV-IN terminals.
S-video Connection
(allows you to make the most of the S-VHS picture performance.)
If your TV is equipped with a S-video input connector
A Perform “RF Connection” previously described.
B Connect the supplied S-video cable between the S-VIDEO
OUT connector on the rear of the recorder and the S-video
input connector on the TV.
C Connect an audio cable between the AUDIO OUT connectors
on the rear of the recorder and the audio input connectors on
the TV.
● Even if you are using audio/video cables to connect your
recorder to your TV, you must also connect it using the RF cable.
This will ensure that you can record one show while watching
another.
D Connect recorder to mains
Plug the mains power cord into a mains outlet.
Basic Connections
Aerial terminal
S-video cable
(provided)
TV
aerial
cable
RF cable
(provided)
AV cable
(not provided)
Mains power
cord
Mains outlet
Back of recorder
S-VIDEO OUT
AV-IN terminals
AUDIO OUT/VIDEO OUT
Back of TV
HR-S6970AG.AJ_EN.fm Page 4 Wednesday, September 15, 2004 11:23 AM
To Next Page
Loading...
