Masterpage:Right
EN 71
Filename [XVC27U_09Editing.fm]
Page 71 6 January 2004 7:51 pm
EDITING (DVD DECK)
Digital Audio
Dubbing
You can dub selected audio from the DVD or Audio CD disc to a
MD etc.
However, it is not possible to dub the copy-protected disc.
Example: Dubbing to a MD
A
Make connections.
Connect the coaxial cable between the unit and the
digital audio device.
B
Place a disc and load a MD.
For the DVD deck
A Press OPEN/CLOSE (x) on the DVD deck to open the
disc tray.
B Place the disc in the disc tray.
C Press OPEN/CLOSE (x) on the DVD deck to close the
disc tray.
For the digital audio device
Insert a MD.
C
Prepare the DVD deck for dubbing.
A Press DVD and select the audio to be dubbed.
B Search for the point where you want to start dubbing
by pressing PLAY (4), FF (5) or REW (3) then
press STOP (8).
C Press REW (3) a little, then press PLAY (4) to start
playback.
D Press PAUSE (9) to pause playback a little before the
start point.
D
Prepare the audio device for dubbing.
Select the input mode.
E
Start dubbing.
A Press PLAY (4) to start playback on the DVD deck.
B Start recording on the audio device.
F
End dubbing.
Stop recording on the audio device. Then press STOP (8)
to stop playback on the DVD deck.
NOTES:
● There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
● You can also dub a Video CD or SVCD. Set “DIGITAL AUDIO
OUTPUT” to “PCM ONLY”. (
墌 pg. 78)
● Turn on the TV and select the VCR channel (or AV
mode).
● Slide the TV/VCR/DVD switch to the right.
Rear of unit
Digital audio device
(MD deck etc.)
Coaxial cable
(not supplied)
DIGITAL AUDIO OUT
Player
Recorder
XVC27U_01.book Page 71 Wednesday, January 7, 2004 10:48 AM
To Next Page
Loading...
