JVC HR-XVC30US - Page 71

EN 37
F
Enter the channel position.
Press
CH +/–
.
G
Set the tape speed.
Press
SP
/
EP
.
H
Return to the normal screen.
Press
PROG.
or
OK
. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM NOT COMPLETED
PROGRAM OVERLAP” appears on the TV screen, see
page 40.
●
Repeat steps
B
–
H
for each additional program.
I
Engage the unit’s timer mode.
Press
TIMER
. The unit turns off automatically and “
#
”
appears on the front display panel.
●
To disengage the timer mode, press
TIMER
again.
To Timer-Record Weekly Or Daily Serials:
— anytime during steps
C
through
G
, press
WEEKLY
(
number
key “9”
) for weekly serials or
DAILY
(
number key “8”
) for daily
serials (Monday – Friday). Either “WEEKLY” or “DAILY” appears
on the TV screen. Pressing the button again makes the
corresponding indication disappear.
NOTES:
●
You can program this unit to timer-record as many as 8
programs. If you try to program the unit to record a ninth,
“PROGRAM FULL” appears on the TV screen. To record the
extra program, you must first cancel any unnecessary
programs. (
墌
pg. 39)
●
In case of a power failure after programing, the unit’s memory
backup keeps your selections for approximately 5 seconds.
●
Programs that start after midnight must have the next day’s
date.
Cable Box or DBS Receiver Users
To timer-record a satellite broadcast using Express Timer
Programing:
A
Perform steps
A
–
I
. Enter “F-1” for the channel position
in step
F
.
B
Set the DBS receiver to the appropriate channel before
the selected program begins.
C
Leave the DBS receiver’s power on.