Error Messages and Actions
Warning display
on the LCD monitor and viewfinder screen, tally lamp indication and warning tone are as
follows according to the error status.
Memo :
0
This camera recorder makes use of a microcomputer. Noise interference from external sources may
prevent it
from functioning properly. When this occurs, turn off and on the power of the camera recorder
again.
Error Message Status Action
Turn Power Off Turn Back On
Later
System error.
* The warning tone sounds and
the tally lamp blinks twice every
second.
Turn off the power, and turn it on
again.
If the error persists, please contact
the local dealers in your area.
Getting Overheated. Please
Turn Power Off.
0
The battery has exceeded the
specified temperature.
0
The power turns off
automatically after about 15
second.
0
Wait
until
the temperature drops
or replace the battery.
0
If the error persists, please
contact the local dealers in your
area.
Rec Inhibited [REC] button is pressed when the
write-protect switch of the SD card
is set.
Turn off the write-protect switch of
the SD card, or insert a recordable
SD card.
(A P
35 [SD Card] )
Lost Media Info *
0
Card is
removed while recording
is in progress.
0
Card is removed while
formatting is in progress.
0
Card is removed while restoring
is in progress.
0
Card is removed while adding
the OK mark.
0
Card is removed while writing a
setup file.
0
Card is removed while deleting a
clip.
(*: A, B)
Restore the card using this camera
recorder.
(A P38 [Restoring the SD Card] )
Record Format Incorrect
0
Video format of the file for Clip
Review is different from the
[Frame & Bit Rate
]
setting of the
camera recorder.
Set [Resolution] and [Frame & Bit
Rate] correctly.
(A P
105 [ Resolution ] )
(A P105 [ Frame & Bit Rate ] )
Media Full
0
[REC] button is pressed when
the media in use has no
remaining space.
0
Remaining
space
ran out during
recording.
Replace the SD card with a new
one.
Error Messages and Actions
127
Others
To Next Page
Loading...
