26
Category Menu item Selectable setting, [reference page]
TUNER
MONO *
4
Monaural mode
• MONO ON
• MONO OFF
: Activate monaural mode to improve FM reception, but
stereo effect will be lost, [10].
: Restore the stereo effect.
IF BAND
Intermediate
frequency band
• AUTO
• WIDE
: Increases the tuner selectivity to reduce interference noises
between adjacent stations. (Stereo effect may be lost.)
: Subject to interference noises from adjacent stations, but
sound quality will not be degraded and the stereo effect
will remain.
AUDIO
FADER*
5
Fader
R06 – F06 : Adjust the front and rear speaker output balance.
(Initial: 00)
BALANCE
Balance
L06 – R06 : Adjust the left and right speaker output balance.
(Initial: 00)
LOUD
Loudness
• LOUD OFF
• LOUD ON
: Cancels.
: Boost low and high frequencies to produce a well-balanced
sound at a low volume level.
VOL ADJUST
Volume adjust
VOL ADJ –05 —
VOL ADJ +05
(Initial: VOL ADJ
00)
: Preset the volume adjustment level of each source (except
FM), compared to the FM volume level. The volume level
will automatically increase or decrease when you change
the source.
• Before making an adjustment, select the source you
want to adjust.
• “VOL ADJ FIX” appears on the display if “FM” is selected
as the source.
BEEP
Key touch tone
• BEEP OFF
• BEEP ON
: Deactivates the keypress tone.
: Activates the keypress tone.
AMP GAIN *
6
Amplifier gain
control
• LOW POWER
• HIGH POWER
: VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speaker.)
: VOLUME 00 – VOLUME 50
*
4
Displayed only when the source is “FM.”
*
5
If you are using a two-speaker system, set the fader level to “00.”
*
6
The volume level automatically changes to “VOLUME 30” if you change to “LOW POWER” with the volume level
set higher than “VOLUME 30.”
EN24-31_DV4506_001A_f.indd 26EN24-31_DV4506_001A_f.indd 26 11/12/08 12:55:26 PM11/12/08 12:55:26 PM