4
Connectable D. player
• You can control the D. player with the cradle connector through this adapter.
For XA-HD500 (firmware version 1.00.0947) users:
Before connecting the D. player to this adapter, update the firmware version of your D. player.
Refer to “Update manual” for details about updating.
Setting your receiver
Before using the D. player through this adapter, make sure to select CD changer as the external input
setting.
• For details, see the PSM setting section in the instructions supplied with your receiver.
Connecting the D. player to the adapter
Connect the D. player connection cable to the cradle connector on the D. player.
• Insert the connection cable until you hear a clicking sound.
To the receiver
The power supply to the D. player is linked to the receiver.
• Make sure to turn off the power on the receiver or turn off the vehicle’s ignition switch before
connecting or disconnecting the D. player.
• While the D. player is connected to this adapter, its battery is charged when the receiver is turned
on.
Starting playback
Turn on the power of the receiver and select the source for CD changer or D. player*.
The D. player starts playback from where it has been previously stopped.
* For receivers which do not show D. player as a source, select CD changer for the source.
For details, see the instructions supplied with your receiver.
KS-PD500
To Next Page
Loading...
Need help?
General
