44
ENGLISH
Setting menu items
• You cannot change <Audio> settings (except <Amplifier Gain>) when the AV source is turned off.
Menu item Selectable setting/item Initial: Underlined
Audio
Fader/Balance Fader : Adjust the front and rear speaker output balance.
♦ F6 to R6; Initial 0
• When using a two-speaker system, set the fader to the center (0).
Balance : Adjust the left and right speaker output balance.
♦ L6 to R6; Initial 0
Press [ 5/∞/2/3 ] or drag [
] to adjust.
• To clear the adjustment, press [Center].
Equalizer
Change the sound mode or adjust and store the equalization for each source.
(☞ page 37)
♦ Flat/Natural/Dynamic/Vocal Boost/Bass Boost/Vibrant/User
Loudness You can activate/deactivate the loudness function.
♦ Off
♦ On
: Cancels.
: Boost low and high frequencies to produce a well-
balanced sound at a low volume level.
Crossover
Adjust the cross over frequency. (☞ page 38)
Volume Adjust
Adjust and store the auto-adjustment volume level for each source. (For
discs, the adjustment is stored for each of the following categories: DVD/
DVD-VR, VCD/CD, and DivX/MPEG1/MPEG2/MP3/WMA/WAV.) The volume
level will automatically increase or decrease when you change the source.
♦ –15 to +06; Initial 00
Amplifier Gain* You can change the maximum volume level of this unit.
♦ High : VOL 00 to 50
♦ Low : VOL 00 to 30
(Select this if the peak power of the speakers is less
than 50 W.)
♦ Off : Deactivates the built-in amplifier.
• If you change this setting from <High>/<Off> to <Low> while the
volume level is set higher than the maximum level of <Low>, the unit
automatically lowers the volume level to “VOL 30”).
* You can change the setting only when the AV source is turned off.
EN_KW-AVX840JJW.indb 44EN_KW-AVX840JJW.indb 44 11/01/19 13:1911/01/19 13:19
To Next Page
Loading...
