JVC KW-M180DBT - Page 22

22
Installation
Ñ Connecting wires to terminals
ANT
CAM IN VIDEO OUT VIDEO IN
AV IN
L
R
FRONT OUTREAR OUT
M4x6
5V
=
1.5A
MIC
SUB
WOOFER
PRK SW
REVERSE
STEERING WHEEL REMOTE INPUT
REMOTE CONT
2 4 6 8
1 3 5 7
2 4 6 8
1 3 5 7
ST REMOTE
INPUT 1
ST REMOTE
INPUT 2
ST REMOTE
GND
ANT DAB
Connect to the vehicle’s
parking brake detection
switch harness.
For best safety, be sure to
connect the parking sensor.
Light Green (Parking sensor wire)
Accessory 9: Extension cable
Purple/White (Reverse sensor wire)
Accessory 4:
Bluetooth Microphone
To steering remote
To use the steering wheel remote control feature,
you need an exclusive remote adapter (not
supplied) matched to your car.
Connect to vehicle’s reverse
lamp harness when using the
optional rear view camera.
Light Blue/Yellow (Steering remote control wire)
Fuse (15A)
Subwoofer Preout
Cap
Cap
FM/AM antenna input
FM/AM
antenna
Connector A
Connector B
USB device
[2]
USB terminal
[1]
(1.0 m)
[1]
USB maximum power supply current :
DC 5 V = 1.5 A
[2]
Sold separately
[3]
KW-M180DBT only
FRONT OUTREAR OUT
VIDEO OUT VIDEO INCAM IN
AV IN
Rear Audio Preout
(Left; White, Right; Red)
AV-IN audio input
(Left; White, Right; Red)
Front Audio Preout
(Left; White, Right; Red)
Visual Output (Yellow)
Rear view camera input (Yellow)
AV-IN visual input (Yellow)
Bright Green/Red
Purple/Red
Gray/Red
Connect to vehicle’s steering remote
harness.
Contact your JVC dealer for details.
DAB antenna input
(SMB connector)
[3]
!
When using a commercially available DAB antenna,
the diameter of the SMB connector must be Φ6.5 mm
or less.
Φ 6.5 mm (maximum)