JVC KW-V640BT - User Interface Settings

45ENGLISH
SettingsSettings
User interface settings
Display the <User Interface> screen.
On the Home screen, touch as follows:
Then, on the <SETUP> screen, touch [User Interface].
<Steering Remote Controller>
(Only for KW-V640BT Region 4)
Assign functions to the keys on the remote controller
of the steering wheel.
• This function is available only when your car is
equipped with the electrical steering remote
controller.
• You can only register/change the functions while
you are parked.
• If your steering remote controller is not compatible,
learning may not be completed and an error
message may appear.
1 When the unit is ready for learning, press
and hold a steering remote controller
button for about 2 seconds to register/
change.
• Refer to the message displayed to confirm
whether the unit ready before proceeding.
2 Select a function to assign to the selected
button.
3 Repeat steps 1 and 2 to register other
functions to other buttons.
4 Touch [Learning completed] to finish
procedure.
A confirmation message appears. Touch [Yes].
• The unit can register/change all of the buttons’
functions at the same time. To do this, press all
buttons in turn and after pressing all of them, touch
[Learning completed] in step 2. However, new
functions cannot be learned after this operation.
• When changing the functions already learned, touch
the assigned function you want to change in step 2
and then touch to select the new function from the
function list.
• Confirm the contents of the settable functions in the
function list. You cannot edit the function list.
To initialize the setting: Touch [Learning
initialization] in step 2.
• A confirmation message appears. Touch [Yes].
– To cancel the initialization, touch [No].
2 Select the folder, then the file for the
background image in the selected folder.
User Background Select
3 Rotate the image (1) if necessary, then
confirm the selection (
2).
A confirmation message appears. Touch [Enter]
to store the new image. (The existing image is
replaced with the new one.)
<Viewing Angle>
Select the viewing angle in relation to the monitor to
make the image on the screen easier to see.
• 0 (Initial)/–1/–2/–3
ENKW-V2018TCKR.indb45ENKW-V2018TCKR.indb45 2017/12/049:412017/12/049:41