JVC KW-V640BT - Wiring Connection

53ENGLISH
REVERSE
PRK SW
¥
REMOTE CONT
STEERING WHEEL
REMOTE INPUT
P.CONT
ANT.CONT
Input 1
STEERING
REMOTE
ST REMOTE
GND
Input 2
«
*2
“
*1
*2
*1
Installation and ConnectionInstallation and Connection
Wiring connection
10 A fuse
Connect the antenna cord to the antenna terminal.
USB input terminal (1 m)
Purple with white stripe
White
] / White with black stripe [
Green ] / Green with black stripe [
Gray ] / Gray with black stripe [
Purple ] / Purple with black stripe [
Orange with white stripe
Light blue with yellow stripe
Blue with white stripe (12 V
350 mA)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
Light green
To the car’s reverse lamp harness when using the optional rear view camera
To the car light control switch
To rear speakers/tweeters*3 (right)
To front speakers/mid range speakers*3 (right)
To rear speakers/tweeters*3 (left)
To front speakers/mid range speakers*3 (left)
Car battery
Car fuse
To the car chassis
To the OE remote adapter (not supplied) which is compatible with your car
Extension wire (
ø )
To the car’s parking brake detection switch harness
(For best safety, be sure to connect the parking sensor.)
Ignition key switch
*1 Only for KW-V640BT Region 1.
*2 Only for KW-V640BT Region 4.
*3 For 3-way speaker system connection, see page 54.
To the power control terminal when using the optional power amplifier (Or)
To the control terminal of the motor antenna or to the power terminal for the booster amplifier of film-type antenna
Gray/Red
Bright green/Red
Purple/Red
Connect to your vehicle’s steering
remote harness.
Contact your JVC dealer for
details.
ENKW-V2018TCKR.indb53ENKW-V2018TCKR.indb53 2017/12/049:412017/12/049:41