JVC KW-V840BT - Controlling Audio; 3-Way Speaker System Setup

Controlling Audio
70
Controlling Audio
You can adjust the various settings such as
audio balance or subwoofer level.
1
Press the [FNC] button.
 Popup menu appears.
2
Touch [ ].
 HOME screen appears.
3
Touch [ ].
 Source selection screen appears.
4
Touch [Audio].
See the following section for each
setting.
• Set up speaker/ X’over (P.71)
• Controlling equalizer (P.73)
• Set listening position/ DTA (P.76)
• Controlling general audio (Fader /
Balance) (P.73)
• Set volume offset (P.74)
• Performing zone control (P.74)
• Set sound effect (P.75)
3 way speaker system setup
Select the appropriate crossover network
mode according to the speaker system (2-way
speaker system or 3-way speaker system).
1
Press the [FNC] button.
 Popup menu appears.
2
Touch [ ].
 HOME screen appears.
3
Touch [ ].
 Source selection screen appears.
4
Touch [AV Off].
5
Press the [FNC] (1) button and the [–] (2)
button for 1 second at the same time.
12
 Speaker system select screen appears.
6
Select the crossover network mode.
 A confirmation screen appears.
7
Touch [Ye s ].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Zone Control
– Fader of Controlling General Audio
– Front focus of Listening Position/ DTA
– Select the speakers to output the sound from
cell-phone of Blutooth HF/Audio
– Beep of User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
!B5A-2303-00b_18KWV-K_En.indb 70 2018/01/09 18:26