Controlling Audio
72
Ñ Crossover network setup
You can set a crossover frequency of speakers.
1
Touch [Xʼover].
2
Touch the speaker to set.
3
Set each item as follows.
■ [HPF FREQ]
High Pass Filter adjustment. (When front or
rear speaker is selected on Speaker Select
screen)
■ [LPF FREQ]
Low Pass Filter adjustment. (When subwoofer
is selected on Speaker Select screen)
■ [Slope]*
1
Sets a crossover slope.
■ [Gain]
Adjusts the front speaker, rear speaker, or
subwoofer level.
■ [TW Gain] *
2
Adjusts the tweeter level. (When front is
selected on Speaker Select screen)
■ [Phase Inversion]*
3
Sets the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When subwoofer is selected
on Speaker Select screen)
*
1
Only when “LPF FREQ”/“HPF FREQ” is set to
a mode other than “Through” in [Xʼover].
*
2
Only when “Tweeter” is set to “Small”,
“Medium”, “Large” in [Speaker Setup].
*
3
Only when “Subwoofer” is set to a mode
other than “None” in [Speaker Setup].
When Speaker network is set to 3 way:
■ [FREQ] (High Pass)
High Pass Filter adjustment. (When tweeter is
selected on Speaker Select screen)
■ [HPF FREQ, LPF FREQ] (Band Pass)
Band Pass Filter adjustment. (When mid
range speaker is selected on Speaker Select
screen)
■ [FREQ] (Low Pass)
Low Pass Filter adjustment. (When woofer is
selected on Speaker Select screen)
■ [Slope]*
1
Sets a crossover slope.
■ [Gain]
Sets gain of each speaker.
■ [Phase Inversion]*
2
Sets the phase of tweeter, mid range, and
woofer output.
Check [Phase Inversion] to shift the phase
180 degrees.
*
1
Only when “LPF FREQ”/“HPF FREQ” is set to
a mode other than “Through” in [Xʼover].
*
2
Only when “Subwoofer” is set to a mode
other than “None” in [Speaker Setup].
NOTE
• For how to switch to the 3-way speaker system,
see 3 way speaker system setup (P.70).
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
!B5A-2303-00b_18KWV-K_En.indb 72 2018/01/09 18:26
To Next Page
Loading...
