Controlling Audio
79English
Controlling Audio
You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [FNC] button.
Popup menu appears.
2
Touch [ ].
HOME screen appears.
3
Touch [ ].
SETUP screen appears.
4
Touch [Audio].
See the following section for each
setting.
• Set up Speaker / X’over (P.80)
• Controlling EQ / SW Level (P.82)
• Set Position / DTA (P.86)
• Controlling Fader / Balance (P.82)
• Set Volume Offset (P.83)
• Performing Zone Control (P.84)
• Set Sound Effect (P.85)
• Use Audio Memory (P.88)
3-way speaker system setup
Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
# CAUTION
• Connecting 3-way speakers with the 2-way
mode selected can break the speakers.
1
Press the [FNC] button.
Popup menu appears.
2
Touch [ ].
HOME screen appears.
3
Touch [ ].
Source selection screen appears.
4
Touch [AV Off].
5
Press the [FNC] (1) button and the [–] (2)
button for 1 second at the same time.
12
Speaker system select screen appears.
6
Select the crossover network mode.
A confirmation screen appears.
7
Touch [Ye s ].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• When the dual zone is selected and audio source
other than "OFF" is selected as Rear Source, the
speaker system cannot be switched.
To Next Page
Loading...
