JVC MX-J570V - Page 16

MX-J570V/MX-J680V
1-16
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly, the front panel assembly, the rear cover /
rear panel, the tuner board, the input / output board
and pre-amplifier board.
Remove the four screws G attaching the transf. on
the power & main amplifier board through the upper
side slots.
Remove the two plastic rivets fixing the power &
main amplifier board.
Remove the cord stopper by pushing it upward.
Cut off the bands k and l fixing the power cord and
unsolder the soldered part on the power & main
amplifier board.
1.
2.
3.
4.
Removing the power & main amplifier
board (See Fig.30 and 31)
Fig.30
Fig.31
G
Power & main
amplifier board
G
G
Plastic rivet
Plastic rivet
Power & main amplifier board
Cord stopper
Soldered part
Band k
Band l