Page 2
Revision level 19.09.2006
Operational Instructions 82021 Code-Combi K - Standard
3 Lock functions
The lock can opened with a single combination code (primary code) or with two codes (primary or secondary code). Only the
holder of the overriding primary combination code is able to release the secondary code.
Primary Code : 6-digit secret combination
Secondary Code : Additional 6-digit combination for further users of the safe
The primary code 1 2 3 4 5 6 is set by works. A secondary code is not set by works.
Primary Code Secondary Code
Programming to be effected only with the lock and safe opened.
3.1 Opening with the primary or secondary code
1)
Press ON
2)
Enter valid 6-digit primary or secondary code
1 x
Lock was opened last with another code
3 x
3)
Within 4 seconds turn bar handle in a clockwise direction until stop position reached
3.2 Opening after 3 incorrect code entries
penalty time
After 3 incorrect entries the lock goes into a one minute blocked status
(during this period it is not possible to enter any further codes)
1 minute
1)
When the blocked period is over ON may be pressed again at any time
2)
Enter valid 6-digit primary or secondary code
1 x
Invalid 6-digit primary or secondary code was entered
3 x
The period in which the lock is blocked is extended to 2, 4, 8 and a maximum of 16 minutes
every time an incorrect code is entered
2, 4, 8 or 16
minutes
3.3 Alteration of the primary code by primary code holder
1)
Open lock with valid 6-digit primary code (see 3.1)
2)
Press ON
3)
Press P
4)
Enter valid 6-digit primary code
5)
Enter new 6-digit primary code / 2 x
6)
Enter new 6-digit primary code again
1 x
If the new primary code as per 6) was incorrectly entered
repeat sequence from 2)
3 x
7)
Test newly programmed primary code by opening once again
3.4 Switching on/alteration of the secondary code by primary code holder
1)
Open lock with valid 6-digit primary code (see 3.1)
2)
Press ON
3)
Press P
To Next Page
Loading...
