Chapter 5
136 Kaba Ilco Lodging Access Control System
Grand Master
Emergency Master
-
-
All
All
* The FDU can be ordered in standard configuration, with available Room level
addresses from 1 to 16,000, or in a custom configuration, with a specified room
range from 1 to 99,999 (see Chapter 6 – Implementing the System).
** Note that each guest room in the facility should have a unique address at the
Guest level. The Guest level for a guest room door includes just one address for
Guest, One-Shot, Pre-registered, and Adjoining Suite keycards, all of which can
give access to the same guest room, but have different expiries or other
features associated with the keycard. These keycards are for different access
levels that share the same address.
*** The Convention Suite address is set using a Convention Suite Reset keycard at
the time the room becomes a part of a Convention Suite (see section 4.10 part
E.5 – Convention Suite Reset). Other types of doors do not have a Convention
Suite address and cannot be part of a Convention Suite.
Equipment required: FDU
Lock communication cable
Initialization keycard
Programming keycard (Not required for RAC)
Completed Planning Forms
Minimum keycard required: Programming Authorization
Steps to program the Guest Room lock addresses:
1. On the lock side, if this is a first time installation, or if power to the lock has
been interrupted, insert the Initialization keycard in the lock. The red and green
indicators should light, then only the green indicator should flash. Re-insert the
Initialization keycard if the pattern of indicator lights described is not observed.
2. On the FDU, swipe a keycard, or enter a PIN value having a Programming
authorized user level.
3. Press 8 or use the down <T> arrow followed by < > to reach the
“Programming FDU/Lock” menu.
To Next Page
Loading...
