Locks – Using and Programming
Kaba Ilco Lodging Access Control System 147
Equipment required: FDU
Lock communication cable
Initialization keycard
Programming keycard
Completed Planning Forms
Minimum keycard required: Programming Authorization
Steps to program the Common Area lock addresses or RACs:
1. On the lock side, if this is a first time installation, or if power to the lock or RAC
has been interrupted, insert the Initialization keycard in the lock or RAC. The
red and green indicators should light, and then only the green indicator should
flash. Re-insert the Initialization keycard if the pattern of indicator lights
described is not observed.
2. On the FDU, swipe a keycard or enter a PIN value having a Programming
authorized user level.
3. Press 8 or use the down <T> arrow followed by < > to reach the
“Programming FDU/Lock” menu.
4. Press 1 or < > to reach the “Lock Programming” menu.
5. Press 4 or use the down <T> arrow followed by <
> to reach the “Program
Common Areas” menu.
To Next Page
Loading...
