Locks – Using and Programming
Kaba Ilco Lodging Access Control System 153
Steps to reset the lock addresses:
1. Program the new lock with the room number only. Refer to Sections 5.3.2, 5.3.3
or 5.3.4 and skip the steps for setting the Sub-Master addresses (Section, Floor,
Group, Zone and Area).
2. Swipe a keycard or enter a PIN value having a Programming authorized user
level.
3. Press 8 or use the down <T> arrow followed by < > to reach the
“Programming FDU/Lock” menu.
4. Press 1 or < > to reach the “Lock Programming” menu.
5. Press 2 or use the down <T> arrow followed by < > to reach the “Reset
Addresses” menu.
6. Insert the Programming keycard in the lock that is to be the source for the
addresses (old lock or a neighbouring lock), and ensure the green indicator is lit.
Connect the communication cable from the FDU to the source lock and press
any key on the FDU to read the addresses and valid keycards.
To Next Page
Loading...
