Chapter 3
44 Kaba Ilco Lodging Access Control System
3.5.5.5 Revoke an existing PIN:
Under certain conditions, the administrator may decide to remove the PIN of an
employee. In the event an employee is leaving or being dismissed, refer to the standard
procedure described in Section 10.7 – If an employee leaves or is fired.
1. Swipe a keycard having a GMA or MA authorized user level.
2. Press 7, or use the down <T> arrow followed by < > to reach the “FDU Setup”
menu
3. Press 3, or use the down <T> arrow followed by < > to reach the “PIN
Management” menu.
4. Swipe the keycard corresponding to the authorized user whose PIN is to be revoked.
To Next Page
Loading...
