Online operation with firmware option Access Manager
k4evo707en-2012-07 35
4.6 Antenna adaptation
The slide switch can be used to calibrate the antenna for mounting on metallic or non-metallic
bases.
Always put the slide switch in the Air position, except when using a metallic base. The slide switch
is set to the Air position on delivery (default).
Position Meaning
In Air position for a non-metallic base;
(default)
In Metal position for a metallic base
4.7 LED display
Displays the access decision and operating state by means of the central light symbol (red/green)
and an acoustic signal transmitter (buzzer).
Error correction tips can be found in Chapter 9/Page 79.
The relevant chapters contain descriptions of signaling during a factory reset and firmware update.
Signaling (default) Meaning
Access signal
Green goes off/on briefly and 1x short beep
Flashing red/intermittent beep
LED flashes green/red and beep
Access authorized/Access allowed
Access not authorized
Access allowed with prompt to update the
badge
Operating state
Green on
Red on
Ready for booking
Access point blocked
Air
Metal
Air
Metal
To Next Page
Loading...