Kaba Saflok SAM RF - Reading the Guard Check Keys

To Next Page

To Previous Page

SAM

RF Operations Manual 118

Section 5: Keys

5.14 Reading the Guard Check Key

When the key is returned, it should be read to view or print the report of where the key was used. The

report will show the last 25 common access locks in which the key was used.

Note: The maximum number of duplicate keys is 64. After you have made 64 duplicate keys, you must

start over by making a new key for that level.

1. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet

and the USB cable between them is properly attached (see Section 2.5 “Installing the Electronic Key

Encoder and Utility Device”).

2. Insert the Guard Check key into the electronic encoder.

3. Point to the Keys pull-down menu and

select Read.

Note: If the key is not currently in the

electronic key encoder, the PC will display

an error screen until you insert a key into

the electronic key encoder.

Note: You must keep the USB cable

connected between the electronic key

encoder base and the PC while the key

image spins on the PC screen.

4. At the Key Read screen, you will see the key type,

who the key was assigned to, the status of the key

and who made the key. Click on Report.