SAM
®
RF Operations Manual 129
Section 5: Keys
© SAFLOK WL 12/20/2007
5.20 Reading Limited Use Keys
After a Limited Use key has been issued and used, you can read the key. Reading the key will allow you
to save the audits from the key. The audits will allow you to see where and when the key was used.
1. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet
and the USB cable between them is properly attached (see Section 2.5 “Installing the Electronic Key
Encoder and Utility Device”).
Note: The utility device need not be in the electronic key encoder to create keys.
2. Click on the Keys menu at the top
of the window or the Keys icon.
3. Click on Read.
Note: If a key is not currently in the
electronic key encoder, you will be
prompted to insert a key into the
electronic key encoder now. You must
keep all the USB cable connected
between the electronic key encoder
base and the PC while the key image
spins on the PC screen.
4. The Key Read PC dialog box displays the key
type, to whom the key was assigned, the status
of the key, the expiration date, who made the
key and the common access locks and unit
numbers the key was programmed to access. At
the bottom left of the screen there is a box to
Save Audits. If you click on the box it will
display the Confirmation Requested PC dialog
box.
To Next Page
Loading...