Kaba Saflok SAM RF - 5.21 Creating Resident;Unit Keys

To Next Page

To Previous Page

SAM

RF Operations Manual 131

Section 5: Keys

5.21 Creating Resident/Unit Keys

Note: The maximum number of duplicate keys is 64. After you have made 64 duplicate keys, you must

start over by making a new key for that level.

1. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet

and the USB cable between them is properly attached (see Section 2.5 “Installing the Electronic Key

Encoder and Utility Device”).

Note: The utility device need not be in the electronic key encoder to create keys.

2. Click on the Keys menu at the top of the

window or the Keys icon.

3. Point to Create, then select Resident

Key.

4. At the Create Resident/Unit Key PC dialog

box, your first task is to select either the

New Key option or the Duplicate Key

option. As with master keys, you must

choose the New Key option each time you

create the first key for a specific unit and

the Duplicate Key option for subsequent

keys created for the same unit.

5. The next step is to go to the Unit pull-

down box and select the appropriate unit.

Units within your property that are

programmed in the SAM RF System will

appear in the pull-down box.